聯系我們

新鄉市恒通電機有限公司

聯系人:張經理

電話:86-0373-2681999

傳真:86-0373-2676888

郵 箱:[email protected]

地 址: 新鄉市牧野區

您當前位置: 首頁 > 新聞中心 > 新聞中心

AEEVF3電機AEEV1H 品牌馬達AEUVF3變頻電機AEUV1H

[ 時間:2018-11-30   點擊:556 ]

AEEVF3電機AEEV1H 品牌馬達AEUVF3變頻電機AEUV1H
新聞詳情:

      AEEVF3電機AEEV1H 品牌馬達AEUVF3變頻電機AEUV1H 特種電機AEEFF3 電動機AEVFF3; TEGH(AEHB)/TVGH   AEEVJ3電機 AEEVJ2電動機 AEUVJ2 馬達 AEUVJ3seven、motor maintenance 0.75HP 1HP 1.5HP 2HP 10HP 15HP 3HP 4HP 5.5HP 1/4HP 1/2HP 1HP
1. The environment, in which the motor is operated, should be kept clean and dry, air inlet should not be hindered by dust or fibers.
2. If the protective devices of the motor operate continuously, it should ascertain whether the fault is from overload operation, it can be put into operation again only after the fault has been eliminated.
3. Should ensure that the motor is in running with good lubrication, according to the different operation conditions, every 500~1000 hours or so, the grease should be
   added or replaced (for closed bearing the grease does not need to be replaced in the whole life). If the bearing is detected with overheating or lubricating grease
   deterioration during operation, should change the grease in time. When changing grease, the old grease should be removed ar first, the oil bearing and bearing cover
   of the oil tank need to be cleaned with kerosene, then grease 1/2 (level 2) or 2/3 (level 4,6,8) of the inner and outer cavity of the bearing.
4. At the end of the bearing life, the vibration and noise will increase when the motor is running, check the bearing radial clearance and replace the bearing.
5. Remove the motor, the fan should be removed first, from the non shaft extension (the back end) out of the rotor. Attention, do not damage the stator
   winding or insulation.
6. When the rotation direction of the motor does not meet the requirements, you can adjust the power phase sequence.
7. When the motor is holding for a long time after use, you should measure the insulation resistance.

使命召唤ol近战冠军